converted denford microrouter compact

[kell]

I am letting go my denford micro router. It has been converted to mach 3
It was fitted with a water-cooled 24000rpm spindle.
I have used it for purely aluminium, but now need something heavier.
the unit measures 670mm wide x 620mm deep x 580mm high {not including VFD Which is fitted at the top.
The bed is 400mm x 200mm
it has a plug jack to connect touch off probe and wired on control board.
Can all be seen working
£1200

[JAZZCNC]

On a side note to anyone looking at this here's some info Kell may not know.? I converted this machine for the previous owner and it's using a quality Cslabs IP-M controller and uses digital stepper drives, I can't remember exactly as it's been a few years but I think they are lead shine EM506.?

It's a very nice little machine.

[kell]

now reduced

[Jem]

Would I be correct in assuming this is in Doncaster?

[kell]

Now sold