davethesteam
19-08-2021, 11:35 AM
The original control system has stripped out ready for conversion to MACH or LinuxCNC, etc. This lathe is based on the Myford ML10. A new control panel has been fitted ready for the next conversion and the Toolchanger converted to a stepper instead of DC motor. The packing plate needs finishing for height and toolchanger position. The lathe is believed to be ex-school (most of these were sold as training lathes) with very little signs of use. Was in full working order before the old control system was removed. £550
Located NE Hampshire GU34
Viewing welcome
NOW SOLD!
Located NE Hampshire GU34
Viewing welcome
NOW SOLD!