JBL_LG
27-01-2022, 08:00 PM
God bless You,
After I had set up Mach3 to use Proma THC 150, plasma torch has stopped cutting material. Not even turning torch on manually by clicking F5 works. Previously it worked. By the way, I use AXBB-E to control plasma cutter.
What should I change in Mach3 configuration to fix problem?
Sincerely,
JBL_LG
After I had set up Mach3 to use Proma THC 150, plasma torch has stopped cutting material. Not even turning torch on manually by clicking F5 works. Previously it worked. By the way, I use AXBB-E to control plasma cutter.
What should I change in Mach3 configuration to fix problem?
Sincerely,
JBL_LG