JBL_LG
08-02-2022, 12:54 PM
God bless You,
when THC function is enabled by clicking "THC" button in Mach3, torch lowers itself down, jet starts cutting and then everything stops. Torch doesn't move, jet doesn't cut. By the way, only THC UP and THC DOWN outputs are connected to AXBB-E. What should I change in Mach3 or Proma THC 150?
Best regards,
JBL_LG
when THC function is enabled by clicking "THC" button in Mach3, torch lowers itself down, jet starts cutting and then everything stops. Torch doesn't move, jet doesn't cut. By the way, only THC UP and THC DOWN outputs are connected to AXBB-E. What should I change in Mach3 or Proma THC 150?
Best regards,
JBL_LG