Denford Triac homing switches

[martin54]

Can someone tell me where the x axis homing/limit switches are located on the Denford Triac please so I at least know where to start looking lol

I know they exist because I have found the wire for them (well I think I have) but I can't physically see the switches anywhere as I can with the Y & Z axis switches. They don't appear to be working so I need to investigate further

[m_c]

http://www.mycncuk.com/threads/10344-Yet-another-Denford-for-the-collection-%28Triac-Retrofit-thread%29?p=86635#post86635

I can't remember the exact location, but at the front of the table. IIRC you need to take the front bellows off, then the mounting bracket unbolts.

[JohnHaine]

Denfordata.com for manuals and drawings.

[martin54]

Thanks, had a look on there but can't see anything about physical location of switches. Downloaded some of that stuff a few years ago & can't remember seeing anything then but knowing there are some members who have done conversions thought asking might help lol

[martin54]

http://www.mycncuk.com/threads/10344-Yet-another-Denford-for-the-collection-%28Triac-Retrofit-thread%29?p=86635#post86635

I can't remember the exact location, but at the front of the table. IIRC you need to take the front bellows off, then the mounting bracket unbolts.

Thanks, yes I removed the front bellows thinking they might be under there but still not visible from what I can see, will have a look at your thread thanks.

[martin54]

Found them thanks m_c I just didn't realise they were on the back of that green plate lol

[EddyCurrent]

Now you know, why not add a picture here to help others with the same problem.

[martin54]

Now you know, why not add a picture here to help others with the same problem.

It was m_c' s post with a link to his conversion post that helped me & should help others.

http://www.mycncuk.com/threads/10344-Yet-another-Denford-for-the-collection-%28Triac-Retrofit-thread%29?p=86635#post86635