Mark121
07-06-2022, 06:05 PM
Evening all, hoping you can help.
I'm trying to inlay a metal sign into some wood.
I've taken a photo of the sign with the best camera I have (my phone) imported it to Aspire as bitmap. Used the Bitmap tool trace, cleaned up the image and then resized to match the real one.
Each time I've run the job its always out a bit. Is there anyway I can make this fit properly. I've attached images so you can see. I'm using ply for practice at the moment as I have an abundance of it.
3107131072310733107431075
Thanks in advance for any help
I'm trying to inlay a metal sign into some wood.
I've taken a photo of the sign with the best camera I have (my phone) imported it to Aspire as bitmap. Used the Bitmap tool trace, cleaned up the image and then resized to match the real one.
Each time I've run the job its always out a bit. Is there anyway I can make this fit properly. I've attached images so you can see. I'm using ply for practice at the moment as I have an abundance of it.
3107131072310733107431075
Thanks in advance for any help