View Full Version : workbee tramming
Andrew C
02-07-2022, 09:40 AM
Is there any easy cheap way to tram the nod on a workbee other than paying over £100 for a gauge
JAZZCNC
02-07-2022, 03:29 PM
Just use the widest cutter you have and write a bit of code to make test cuts for both directions on a piece of scrap then adjust as required, doesn't take very long and no gauges are required.
Powered by vBulletin® Version 4.2.5 Copyright © 2025 vBulletin Solutions Inc. All rights reserved.