scot2go
16-01-2023, 09:36 AM
Hello there,
I have a Pacer 25-12K CNC with XMC-E 2.63 native software. I have been told that the latest version is version 3.
I would prefer to have the Pacer upgraded to run on a OS rather than the present as the sole engineer who seemingly services these Pacer machines has basically decided to ignore my job.
Can anyone take on this reconfiguration?
I presently use VCarve to design etc the projects before submitting it to the Pacer but I have seen far more comprehensive native software packages used on other machines that would broaden my range & scope.
If there are any other Pacer users on this Forum .... I would be grateful if you could contact me for general advice and or if they have managed to benefit from any XMC-E software upgrade.
Sam Mitchell
I have a Pacer 25-12K CNC with XMC-E 2.63 native software. I have been told that the latest version is version 3.
I would prefer to have the Pacer upgraded to run on a OS rather than the present as the sole engineer who seemingly services these Pacer machines has basically decided to ignore my job.
Can anyone take on this reconfiguration?
I presently use VCarve to design etc the projects before submitting it to the Pacer but I have seen far more comprehensive native software packages used on other machines that would broaden my range & scope.
If there are any other Pacer users on this Forum .... I would be grateful if you could contact me for general advice and or if they have managed to benefit from any XMC-E software upgrade.
Sam Mitchell