UC300 controller wiring to steppers drivers

[lateAtNight]

Does anyone know the UC300 (https://www.nvcnc.net/uc300.html) "Digital Dream" controller card by Novusun? For each axis, it has Pulse +/- and Dir +/-, no 5V output. The stepper drives that I have only takes a 5v input and step and dir (see attached image). Is it possible to wire these drives to the controller?

Many thanks 🙏.

3192331924

[m_c]

It should work if you provide 5V to the drive + pin (5V needs to have a shared gnd with the controller), then only connect the step/dir - outputs to the drive Step/dir inputs.

[lateAtNight]

Guess I'll need to get a 5v supply because there is nothing on the controller :(.

Thanks for the reply!

[m_c]

Check the COM+ pin for 5V

[JohnHaine]

If you need a 5 supply then a USB wall wart is a quick and cheap solution - old phone charger.