Twigz
07-01-2024, 05:15 PM
Hi all,
I've got a 8'x4' router with no manual or no knowledge about the machine.
It connects to the computer with a 15 pin connector (DB-15). Tried running it on the Mach3 software but it seems I have no connection at all.
I would like to change the control card to a USB or ethernet connection but I have no clue what to look for.
The machine has 4 of the DMA860H steppen drives installed if that's any help?
Any suggestions on what board to replace it with?
32100
32101
32102
I've got a 8'x4' router with no manual or no knowledge about the machine.
It connects to the computer with a 15 pin connector (DB-15). Tried running it on the Mach3 software but it seems I have no connection at all.
I would like to change the control card to a USB or ethernet connection but I have no clue what to look for.
The machine has 4 of the DMA860H steppen drives installed if that's any help?
Any suggestions on what board to replace it with?
32100
32101
32102