Log in

View Full Version : NEW MEMBER: hello from oxfordshire



artisan
22-12-2024, 11:17 PM
Hi there. I am new to the CNC world. I hope to love working with the new desktop CNC I recently bought. But am have some problems.

I was trying to change the speed settings on VFD and mistakenly cleaned all the settings back to their default.
The machine is an itech k6090t CNC with a delta sm300 VFD. It runs a 2.2kw water-cooled spindle, the controller is rich auto A11E

If anyone has the setting that would be a great help.

Thanks
ben

Chaz
23-12-2024, 05:15 PM
Isnt there a manual for the VFD somewhere? Where in Oxfordshire?

artisan
24-12-2024, 02:26 PM
HI chaz, yes there is a manual oniline. i am near banbury.

Chaz
24-12-2024, 07:08 PM
So is that you dont know what the settings should be to allow the machine to run again?

artisan
26-12-2024, 12:04 PM
Yes, that is right. The machine was working. I was looking for the right setting to put back into the VFD. I did find some, which are below. But the controller does not seem to turn the spindle on. I am NOT sure if these are the right settings for it. That is why I was hoping someone would have them. The manual is a bit confusing to me as I am new to the CNC and VFD world.

00.21=1
01.00=400
01.01=400
02.16=2
02.17=34
03.11=101.0
05.01=8.00
05.02=2.20
05.04=2
05.03=23999
06.06=4
06.08=5.0
07.01=40
07.02=2.0
07.03=2.0
07.04=5.00

artisan
26-12-2024, 12:31 PM
3244232443

Chaz
31-12-2024, 12:27 AM
The attachments dont work but Ive found a manual.

00-23, is that set to 0?

If you bridge the terminal for 'run', does it start?

Are you giving it a speed reference and if so, how?

00-30, should be set to 2 and then PR3-00 should be set to 1 (default).

Why is 3-11 101 and not 100%?

5.03 should be 24000 most likely.

Might be worth me giving you a call to help. PM Me a number that I can Whatsapp you on, as you can then show me what you see etc.

Lee Roberts
08-01-2025, 11:41 PM
Hi there. I am new to the CNC world. I hope to love working with the new desktop CNC I recently bought. But am have some problems.

I was trying to change the speed settings on VFD and mistakenly cleaned all the settings back to their default.
The machine is an itech k6090t CNC with a delta sm300 VFD. It runs a 2.2kw water-cooled spindle, the controller is rich auto A11E

If anyone has the setting that would be a great help.

Thanks
ben

Hi Ben welcome to the community and good luck with your adventure!