Mark Murphy
12-02-2010, 07:44 PM
Hi Guys,
I'm new here, so I hope I'm not asking a stupid question!! But I'm doing a job at work on a Hurco VM2 and I'm hoping to use the 3D milling option.
The only problem is I've NEVER done this before :eek:!!! I was wondering if anyone knows of an online tutorial I could use to get me over the hump of starting. Much appreciated.
Mark
I'm new here, so I hope I'm not asking a stupid question!! But I'm doing a job at work on a Hurco VM2 and I'm hoping to use the 3D milling option.
The only problem is I've NEVER done this before :eek:!!! I was wondering if anyone knows of an online tutorial I could use to get me over the hump of starting. Much appreciated.
Mark