GeorgeD
31-07-2010, 05:26 PM
Trying to drill a series of 3 or 4 holes in a spanner shaft without any joy :mad:
The spanner is dropped forge steel and the HSS bits have just about scratched the sufacelol
Any ideas to get me out of a pickle?
This spanner is pemanently located under my router table in a manner it will be withdrawn from the collet nut and fed onto the nut when needed but I need to cut/drill a cutout in the shaft for it to go on the arc slide here.....
The spanner is dropped forge steel and the HSS bits have just about scratched the sufacelol
Any ideas to get me out of a pickle?
This spanner is pemanently located under my router table in a manner it will be withdrawn from the collet nut and fed onto the nut when needed but I need to cut/drill a cutout in the shaft for it to go on the arc slide here.....