Karl
05-07-2011, 06:37 PM
First project is to convert an X-Y table to Mach3 control. The primary aim here is to learn about the Mach3 software.
So we have on the table (from Zapp):
Stepper Motor: SY60STH88-300*BF (qty 2)
Drivers: PM542 (qty 2)
Power Supply: EP002G1 (qty 1)
Breakout Board: ZP5A-Int 5
Now at this point we would really appreciate if someone would kindly assist by providing a wiring diagram for all of the above.
(Of course, this would be a good point for someone to suggest/recommend an alternative to Mach3)
Many thanks
Karl
So we have on the table (from Zapp):
Stepper Motor: SY60STH88-300*BF (qty 2)
Drivers: PM542 (qty 2)
Power Supply: EP002G1 (qty 1)
Breakout Board: ZP5A-Int 5
Now at this point we would really appreciate if someone would kindly assist by providing a wiring diagram for all of the above.
(Of course, this would be a good point for someone to suggest/recommend an alternative to Mach3)
Many thanks
Karl