John S
09-08-2007, 11:51 PM
Hi, my name is John Stevenson and I'm a CNC addict, need I say more ? ;)
I run a small engineering firm just outside Nottingham at Long Eaton that caters for emergency repair work.
My part time interests are with small home shop CNC machines although I have done full sized conversions.
At the moment my main projects are the Sieg X3 CNC conversion that Arc Eurotrade sells.
http://www.arceurotrade.co.uk/en-gb/dept_262.html
I also have other projects on the go but at the moment these are under wraps until finished.
If anyone is going to the Bristol Model Engineering show next week end 17th, 18th and 19th then you may see a couple there.
We are also going to the Model Engineering show at Ascot race course in September [ not sure of dates ] and will be part of the past, present and future SMEE Centenary exhibition. We will have a X3 mill and a Techno Isel router there and also be doing some talks on getting started with CNC in the home shop.
Software wise we are big believers in UK products and use Dolphin and also V Carve from Vectric Software, it's awesome.
Enough for now.
John S.
I run a small engineering firm just outside Nottingham at Long Eaton that caters for emergency repair work.
My part time interests are with small home shop CNC machines although I have done full sized conversions.
At the moment my main projects are the Sieg X3 CNC conversion that Arc Eurotrade sells.
http://www.arceurotrade.co.uk/en-gb/dept_262.html
I also have other projects on the go but at the moment these are under wraps until finished.
If anyone is going to the Bristol Model Engineering show next week end 17th, 18th and 19th then you may see a couple there.
We are also going to the Model Engineering show at Ascot race course in September [ not sure of dates ] and will be part of the past, present and future SMEE Centenary exhibition. We will have a X3 mill and a Techno Isel router there and also be doing some talks on getting started with CNC in the home shop.
Software wise we are big believers in UK products and use Dolphin and also V Carve from Vectric Software, it's awesome.
Enough for now.
John S.