View Full Version : NEW MEMBER: Hi from QLD Australia
I live in Hervey Bay - N of Brisbane. I have fair experience of normal machining and am converting a small manual mill to CNC. Setup with Mach 3, Routout CNC kit etc - but presently unable to get any drives to run - still trying
blackburn mark
06-10-2011, 04:13 PM
presently unable to get any drives to run - still trying
frustraiting ! but keep the faith and try your best to crack it without reading the whole 300 pages of the mach manual :heehee:
your probably in for some heart ach n pain but iv yet to meet the person that has been through it all and not thought it all worth while in the end :smile:
good luck
Jonathan
06-10-2011, 05:04 PM
Can you tell us what the symptoms, if any are? Might be able to assist...
Powered by vBulletin® Version 4.2.5 Copyright © 2025 vBulletin Solutions Inc. All rights reserved.