abfa9358
02-01-2012, 11:02 PM
Hi All,
I need to free up some shed space and have the following for sale:
1. Chester Conquest Mill
CNC conversion completed. Nook 5/8" dia. x 0.2" ball screws on X and Y. SKF (ebay) 5 x 20mm ball screw on Z. Home made Z mount with belt reduction and two thrust bearings mounted in 30mm aluminium block. Little Machine Shop belt drive conversion. Small damage to table (see picture). Instruction manual and bits removed during conversion included.
2.Chester 3" milling vice, handle and studs.
3.Motion Control Products MSD542 stepper drives.
4.Two home brew BoB's (I can supply wiring diagram).
5.Three off stepper motors purchased from Motion Control Products.
Buyer to collect (Bristol), I can strip mill in to component parts if required.
I wish to sell in one go.
£800 ono.
I need to free up some shed space and have the following for sale:
1. Chester Conquest Mill
CNC conversion completed. Nook 5/8" dia. x 0.2" ball screws on X and Y. SKF (ebay) 5 x 20mm ball screw on Z. Home made Z mount with belt reduction and two thrust bearings mounted in 30mm aluminium block. Little Machine Shop belt drive conversion. Small damage to table (see picture). Instruction manual and bits removed during conversion included.
2.Chester 3" milling vice, handle and studs.
3.Motion Control Products MSD542 stepper drives.
4.Two home brew BoB's (I can supply wiring diagram).
5.Three off stepper motors purchased from Motion Control Products.
Buyer to collect (Bristol), I can strip mill in to component parts if required.
I wish to sell in one go.
£800 ono.