Golfer4588
15-01-2012, 03:12 PM
Hi,
I was hoping someone could give me some help with my Dore Westbury milling machine. I‘m not sure what the model number is though. (picture attached below)
I have absolutely no experience with milling machines so am finding things very confusing.
I need to be able to skim a fraction of material using a fly cutter.
As I mill across the material (winding away from me) the cut my side of the spindle is deeper than the cut the other side.
I have done a bit of research and I think the pitch of my machine is out?
I can see how you would adjust the yaw (which seems fine) but I cannot see how you could adjust the pitch?
Any help regarding this matter would be very much appreciated.
Many thanks
Richard
http://i.ebayimg.com/00/s/NzY4WDEwMjQ=/$(KGrHqFHJDcE63Z(jjCLBO0o!bIsNQ~~60_12.JPG
I was hoping someone could give me some help with my Dore Westbury milling machine. I‘m not sure what the model number is though. (picture attached below)
I have absolutely no experience with milling machines so am finding things very confusing.
I need to be able to skim a fraction of material using a fly cutter.
As I mill across the material (winding away from me) the cut my side of the spindle is deeper than the cut the other side.
I have done a bit of research and I think the pitch of my machine is out?
I can see how you would adjust the yaw (which seems fine) but I cannot see how you could adjust the pitch?
Any help regarding this matter would be very much appreciated.
Many thanks
Richard
http://i.ebayimg.com/00/s/NzY4WDEwMjQ=/$(KGrHqFHJDcE63Z(jjCLBO0o!bIsNQ~~60_12.JPG