bigskelf
04-04-2012, 01:52 PM
Newbie here from far north of Scotland. Mostly a wood worker but use cnc engraver mainly on silver and trophy metal.
Sadly my dahlgren wizzard 2000ST has had a fatal logic board failure and I'm currently running a little Metaza to keep the business going.
However I have high hopes of performing a brain transplant on the dead wizzard
Hoping some folks can point me in the right direction as I would really like to get the wizzards steppers back in action
Here's a view of the goosed boards (y axis failed) I'm hoping to retro fit new controller in their place and put the whole beast back in it's original casing. Any Dahlgren/suregrave gurus out there?
56655666
Sadly my dahlgren wizzard 2000ST has had a fatal logic board failure and I'm currently running a little Metaza to keep the business going.
However I have high hopes of performing a brain transplant on the dead wizzard
Hoping some folks can point me in the right direction as I would really like to get the wizzards steppers back in action
Here's a view of the goosed boards (y axis failed) I'm hoping to retro fit new controller in their place and put the whole beast back in it's original casing. Any Dahlgren/suregrave gurus out there?
56655666