So... what do you plan to do over the hols?

[irving2008]

As the title says...

I have so much I want to do...

Paint my mill stand
Fit its adjustable feet
Get the mill onto the stand and set it up
Pour a new rear bearing for the lathe
Make the Z-gantry for my PCB router/mill
Change the rear pads/discs on the car, get some new tyres and get it MOT'd

and a host more...

how much will i achieve...

I suspect very little....

[Robin Hewitt]

Well, I was rather hoping to have a holiday, but I don't think it's going to happen. OTOH catching up a bit would be nice :rolleyes:

[Robin Hewitt]

Got to clear some space, just bought in injection moulder off ebay :beer:

[irving2008]

Got to clear some space, just bought in injection moulder off ebay :beer:what about the one you built? is that redundant now (and a lot smaller!)

[Jeremy]

Good luck with the good intentions to do stuff over the break - I'm planning on giving my workshop a big clearout, but strongly suspect that it will still be in the present untidy state at the end of the holiday.............

Jeremy

[Robin Hewitt]

Hi Irving

I built an extremely compact moulder because I didn't have the space for a big one.

I now have space. One of the basic rules of business is that that you always start from where you are now.

Here's a fun DIY injection mould link...

http://www.dms-diemould.co.uk/

And a fun finishing link...

http://www.caswelleurope.co.uk/index.htm

best

Robin

You and Jeremy, in the words of RoboCop, "Thank you for your co-operation" :beer: