manofgresley
16-08-2012, 04:02 PM
Hi All
Not sure if this is the right section for this, but here goes.
I now have my Stepper motors & Drivers, a Breakout Board and PSU. My question is this - What size/gauge wires do I need to connect these items (The Motors are already wired). Can anyone supply I good hard wire schematic I could use. I appreciate I need a panel mounted E Stop & On/Off switch, but do I need to put in extra fuses, in the control (240vac) circuit?
Regards
Ray
Not sure if this is the right section for this, but here goes.
I now have my Stepper motors & Drivers, a Breakout Board and PSU. My question is this - What size/gauge wires do I need to connect these items (The Motors are already wired). Can anyone supply I good hard wire schematic I could use. I appreciate I need a panel mounted E Stop & On/Off switch, but do I need to put in extra fuses, in the control (240vac) circuit?
Regards
Ray