Fivetide
06-10-2012, 02:45 PM
So can anyone help with this problem?
I can’t work out what the federate should be set in NCstudio. Below are the machines stats :
Spindle spec:
Spec: 65*210 mm (Diameter:65mm x Length:210mm)
Power: 800W
Voltage: 220V~250V
Frequency: 400 Hz
Speed: 8000-24000 R/min
ER11 collet chuck
Stepper drivers:
Input Voltage: 220V-240 V, 50/60HZ
Output Voltage: 0-240 VAC
Output Power: 1.5 KW
Output Frequency: 0-400 Hz
Output Current: 7.0 A
Capacity: 2.8 KVA
Overload Capacity: 10.5 (60s)(A)
Stepper Motors:
Step Angle: 1.8 degree
Voltage: 1.8V
Current: 3.0A/phase
Resistance: 0.50hm/phase
Inductance: 1.8mH/phase
Torque: >=450mN. m
Number of wire leads: 4
Length: 65 mm
The default seems to be set at 2200 in the picture its set to 600
7079
If you open the parameters you can alter these as below on the fly, I cant work out what they mean by G01 G02 G03 and then the other G00?
7080
My machine is rated at 4000 mm/min
7081
And the artcam feedrate for the tool is 76 mm/min
7082
You can also set them in the main parameters settings
7083
The problem I have is when I run a job I have to lower the feed rate to 20% this cuts the correct width and length but 3 x’s to deep, I can’t seem to work out how to set up the G00 code etc to match the machine.
I can’t work out what the federate should be set in NCstudio. Below are the machines stats :
Spindle spec:
Spec: 65*210 mm (Diameter:65mm x Length:210mm)
Power: 800W
Voltage: 220V~250V
Frequency: 400 Hz
Speed: 8000-24000 R/min
ER11 collet chuck
Stepper drivers:
Input Voltage: 220V-240 V, 50/60HZ
Output Voltage: 0-240 VAC
Output Power: 1.5 KW
Output Frequency: 0-400 Hz
Output Current: 7.0 A
Capacity: 2.8 KVA
Overload Capacity: 10.5 (60s)(A)
Stepper Motors:
Step Angle: 1.8 degree
Voltage: 1.8V
Current: 3.0A/phase
Resistance: 0.50hm/phase
Inductance: 1.8mH/phase
Torque: >=450mN. m
Number of wire leads: 4
Length: 65 mm
The default seems to be set at 2200 in the picture its set to 600
7079
If you open the parameters you can alter these as below on the fly, I cant work out what they mean by G01 G02 G03 and then the other G00?
7080
My machine is rated at 4000 mm/min
7081
And the artcam feedrate for the tool is 76 mm/min
7082
You can also set them in the main parameters settings
7083
The problem I have is when I run a job I have to lower the feed rate to 20% this cuts the correct width and length but 3 x’s to deep, I can’t seem to work out how to set up the G00 code etc to match the machine.