Nealieboyee
28-10-2012, 12:01 AM
Hi All,
While I'm waiting to build my CNC router (Saving up for the electronics and lead screws), I thought I'd have a go at building a small desktop wood lathe for pen turning, shaping acrylic etc.
I'm stuck on the motor type to use. A 1/2hp motor is probably waaay too large for my application. Would going DC be better with regards to speed control? I'm on a really tight budget, so I can't splash out hundreds of pounds for a motor. I just need something small with enough torque.
So my questions:
1. DC or AC
2. If DC, then brushed or brushless (brushless being quite expensive)
3. What size and voltage? (No 3-phase supply so i'm limited to mains)
Your input would be very much appreciated.
Kind regards,
Neal
While I'm waiting to build my CNC router (Saving up for the electronics and lead screws), I thought I'd have a go at building a small desktop wood lathe for pen turning, shaping acrylic etc.
I'm stuck on the motor type to use. A 1/2hp motor is probably waaay too large for my application. Would going DC be better with regards to speed control? I'm on a really tight budget, so I can't splash out hundreds of pounds for a motor. I just need something small with enough torque.
So my questions:
1. DC or AC
2. If DC, then brushed or brushless (brushless being quite expensive)
3. What size and voltage? (No 3-phase supply so i'm limited to mains)
Your input would be very much appreciated.
Kind regards,
Neal