flat work needed

[kristof]

Hi everyone
I need 2 frame plates cut out of carbon fibre approximetly 20cm in diameter and 1mm depth and about 6 motor holders about 4x2 cm and 2mm depth. I would supply carbon fibre plates. I attach raugh drawing. Can you tell me for how much would you do it for me?74327433

[Jonathan]

I can make that. For the 20cm diameter part is it just the blue outline and lots of holes?

[Fivetide]

ahh Ahhh .. the quad coptor with more arms .. project number 1010.. lol, let me know how it goes kristof

[r0bsk1]

A hexacopter. What flight controller are you using? I have a fully autonomous hex with APM2.

[kristof]

I can make that. For the 20cm diameter part is it just the blue outline and lots of holes?

Cool . Yes the blue outline and lots of holes.Can u give me a rough estimate?

[kristof]

ahh Ahhh .. the quad coptor with more arms .. project number 1010.. lol, let me know how it goes kristof

I will do so:),hope I'll have enough persistence to do it, and Jonathans won't charge me too much so I can kick start:D

[kristof]

A hexacopter. What flight controller are you using? I have a fully autonomous hex with APM2.

thats cool,please post some pictures so we can have look:),I'm planning to use mulitcopter KK V5.5 board

[kristof]

Hello guys,have given up on me?:)can someone give me a quote,please:)