gr8fun
26-11-2012, 01:24 PM
Hi all
I've just discovered this site while browsing the CNCZone forum.
It seems much better to have a UK based forum!
I'm currently in the planning stage of a small, probably 4ft x 4ft plasma table.
This will be used at home to prototype ideas for my small home based business.
All of this dictates I will be working on a budget! However, the good thing is the products I intend to make have little need of "fine" tolerances.
I had thought I would starting tonight.. but a recent thread has caused me to question my plans - so I'm back to square 1.
I'll not clog up the intros section with my quandary, hopefully I'll see you in the plasma section soon!!!
Ta ta for now
Danny
I've just discovered this site while browsing the CNCZone forum.
It seems much better to have a UK based forum!
I'm currently in the planning stage of a small, probably 4ft x 4ft plasma table.
This will be used at home to prototype ideas for my small home based business.
All of this dictates I will be working on a budget! However, the good thing is the products I intend to make have little need of "fine" tolerances.
I had thought I would starting tonight.. but a recent thread has caused me to question my plans - so I'm back to square 1.
I'll not clog up the intros section with my quandary, hopefully I'll see you in the plasma section soon!!!
Ta ta for now
Danny