Sodster68
21-01-2013, 12:29 PM
Hi all,
I'm a bit confused as to what the minimum requirements are on a break out board. My planned system is a PC with LinuxCNC, BOB, drivers and stepper motors.
Take this for instance:
8001
Obviously there are no opto couplers to protect the computer. But is anything else needed for comunicating with the stepper drivers?
Thanks
Patrik
I'm a bit confused as to what the minimum requirements are on a break out board. My planned system is a PC with LinuxCNC, BOB, drivers and stepper motors.
Take this for instance:
8001
Obviously there are no opto couplers to protect the computer. But is anything else needed for comunicating with the stepper drivers?
Thanks
Patrik