chalfontcrew
04-02-2013, 12:18 AM
I have a new milling cutter that i wont be needing now.
It hasnt been used
It is made by ITC and is Colbalt Steel (very hard and heavy)
It has 2 cutting flutes and its size is as follows
20mm diameter
150mm Long
The weight if this item is 600 grams
I think this will chew threw most steels with ease
I am looking for about £10 (would cost £40+ in shop) and about £3 to deliver depending where you live.
Or you can pick it up i live in the amersham, buckinghamshire area
I hope this will be usefull to someone
Email [email protected]
It hasnt been used
It is made by ITC and is Colbalt Steel (very hard and heavy)
It has 2 cutting flutes and its size is as follows
20mm diameter
150mm Long
The weight if this item is 600 grams
I think this will chew threw most steels with ease
I am looking for about £10 (would cost £40+ in shop) and about £3 to deliver depending where you live.
Or you can pick it up i live in the amersham, buckinghamshire area
I hope this will be usefull to someone
Email [email protected]