Conan257
22-04-2009, 04:32 PM
I'm after a rough costing for anyone willing to do some work for me on the attached file...
It is 5 panels made from 5mm perspex that I'm happy to supply, so I'm not after material costs being included.
I've attached the .nc files that have been set up for a 2mm flat end bit and 500x500mm perspex, although I can change this if needed. Maximum size of the panels is 300x300mm, all cuts are 5mm (entirely through the material).
The job consists of:
1x Side Panel 1
1x Side Panel 2
2x Side Panel 34
1x Motherboard Tray
2x 300mmx300mm plain pieces
Think thats about all the info you'd need. If anyone can give me some pointers as to if the manufacture is possible from these files or whether more info is needed then please let me know. I'd like these done so I have a comparison for when I complete my own router.
It is 5 panels made from 5mm perspex that I'm happy to supply, so I'm not after material costs being included.
I've attached the .nc files that have been set up for a 2mm flat end bit and 500x500mm perspex, although I can change this if needed. Maximum size of the panels is 300x300mm, all cuts are 5mm (entirely through the material).
The job consists of:
1x Side Panel 1
1x Side Panel 2
2x Side Panel 34
1x Motherboard Tray
2x 300mmx300mm plain pieces
Think thats about all the info you'd need. If anyone can give me some pointers as to if the manufacture is possible from these files or whether more info is needed then please let me know. I'd like these done so I have a comparison for when I complete my own router.