nobby
11-05-2014, 03:45 PM
H-Bot 3D Printer HB1 dry test No.22 - YouTube (http://www.youtube.com/watch?v=yZm4TXPPlTo)
anyone done that yet?
with the torch height from a cable
????????
yes, with dual shaft motors, with twin belts top and bottom or single?
twin bar y axis with turn-buckles each end between them for tensioning.
does anyone make a idler pulley mount that slots into 45mm t-slot ends
would you use a single 25mm belt 2525mm long closed loop and get a table about 400mm square
2525mm divided by 6 -= 420mm square so 600 by 220 or 500 by 320mm
or would you d twin 15mm pulleys top and bottomso as to not stress the motor shafts so much
COULD you in fact run 4 motors one in each corner
anyone done that yet?
with the torch height from a cable
????????
yes, with dual shaft motors, with twin belts top and bottom or single?
twin bar y axis with turn-buckles each end between them for tensioning.
does anyone make a idler pulley mount that slots into 45mm t-slot ends
would you use a single 25mm belt 2525mm long closed loop and get a table about 400mm square
2525mm divided by 6 -= 420mm square so 600 by 220 or 500 by 320mm
or would you d twin 15mm pulleys top and bottomso as to not stress the motor shafts so much
COULD you in fact run 4 motors one in each corner