View Full Version : Denford Easiturn 3 spindle alignment

05-06-2014, 09:14 PM
Hi there, does anyone know how to realign the head/spindle on an Easiturn 3? I have one and it runs out quite badly.

The Denford site is as usual little to no help.

There's a couple of us wanting to know, so any information would be greatly appreciated.


11-12-2014, 04:58 PM
hi i had the same problem if you take the small cover that gives access to the spindle off there is a caphead bolt in each corner of the headstock base if you undo them there is a small amount of movement in the headstock that will allow you to move the spindle side to side.
cheers glen

Colin Barron
13-05-2020, 10:23 AM
could you please tell me what lubrication is required for the Easiturn 3 i am now rebuilding. I read that Mobil Vactra3 is ok for the centralised lube but what is used for the workhead spindle. It looks like the chuck end of the spindle has a grease nipple but when i removed the spindle bearings there was no evidence of any grease.

Colin Barron
13-05-2020, 10:28 AM
When i removed my headstock one of the bolts was sheared, so worth checking.