150mm dia x 15mm wall Ali pipe

[r0bsk1]

Hi, Anyone know where i can source a short length of about 50-100mm of the above at a reasonable price please?

I have found a 150mm solid bar and then machine out the excess but it'd be nice to need to machine it.

TIA

[johnsattuk]

I have 140mm x 10mm wall :apologetic:

[r0bsk1]

Oooh that's so close ill remeasure just in case. How much is it and can you cut to size?

[johnsattuk]

How much do you need, I can cut but will be with a bandsaw/jigsaw so will not be accurate, you will have to clean up.

Maybe be possible to part off in my lathe with a bit of jiggery pokey, :sneakiness: how accurate do you need

[r0bsk1]

Lets say 75mm of tube. This will give me 5mm for cutting and adjustment.

[irving2008]

I hope you meant 75mm lol :)

[r0bsk1]

Yup i did. edited....

Think the bike would fall over with 75m stuck to the side of it

[johnsattuk]

Hi

Have dragged it out of my loft where it has been for ~50yrs

May not be what you want now that I have got it where I can measure it. I guess it is actually 5.5" od with .375 wall ( 149.5 x 9.6 )

I don't know the spec but it rings quite well and machines OK, it was an off-cut from the switch arms at a large sub-station.

12559

~80mm would be £10 in the post.

[r0bsk1]

Cool its worth a shot for a tenner :thumsup: Paypal ok for you?
How much of it do you have? I might have the rest if it fits

[johnsattuk]

PayPal OK, same as my addr. PM your address to send to.

Got about 240mm left, also have ~450mm x 118 OD x 110 ID. from same source.