Hello everyone !

[Wobbin]

Hello all, new to the site just.

I'm a forty something newbie to CNC at least in terms of using mills etc, but I have a background in Electronics and spent a couple of very interesting years not too long ago doing component level repairs on CNC controllers, VFD's, servo's, power supplies and PLC's for a local company.

Whilst creating some brackets to mount infra red heater elements for my latest project (toaster reflow oven) - by hand - I got to thinking "There must be a better way !", so I started looking for a cheap mill.

I quickly realised that there is a large range of good and not so good equipment and that I would find a lot of value in 'lurking' with the professionals and tapping in on their experience - so here I am :tears_of_joy:

Hopefully in return I may be able to give something back to the forum.

Kind Regards,
Robin Commander

[JAZZCNC]

Welcome Robin,

So you can repair VFD's.? Well get ready for it your just about to get mobbed by loads of folks with blown VFD's tapping up your services. . Including me.:hysterical:

That said feel free to tap into me and my experience.

[longy]

Hi Robin, welcome to the forum. I am sure with your knowledge and experience in electronics will make you a valued member of this forum. A cnc that makes toast now that's a good idea LOL as it will make a welcome change from Drivers and VFD's becoming toast.
Mike :)

[JAZZCNC]

That said feel free to tap into me and my experience.

Just read that again it just sounds plan wrong. . :hysterical:

[Wobbin]

Just read that again it just sounds plan wrong. . :hysterical:

Thanks for the welcome guys :-)