View Full Version : Milling M/c speed increaser
StevenT
15-07-2014, 08:33 PM
Hi
Just finished make this speed increaser, its by Hemingway kits with a ER11 chuck instead of the
6mm tool holder and grub screw as in the kits spec. the unit gives a 3X speed increase.
so far its works very well.
12807
Lee Roberts
16-07-2014, 08:11 AM
That looks cool how dose it work?
StevenT
16-07-2014, 09:46 AM
Hi Lee
its a epicyclic gear box that gives a speed step-up of 3X spindle RPM, the low speed input shaft has a internal cut gear wheel then an intermediate gear that drives the sun wheel.
The Kit came with all the gears and bearing.
http://www.hemingwaykits.com/acatalog/Speed_Increaser.html
Lee Roberts
16-07-2014, 10:34 PM
Hi Steven, thanks I didn't have time before to look at their website but I've just had a good look around, thanks for sharing I've bookmarked a few things for later usage.
I may have a go at the roller bender, though will probably just order the Thomas books first.
.Me
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.