petejw
12-03-2015, 10:16 PM
Hi
Ive had this 4 wire motor lying around for a couple of years, and it bugged me back then. Ive just started to look at dabbling with CNC, this time with the arduino and its bugging me again.
Has anyone come accross these? I suspect its out of an old printer. The only markings are on the bottom of the case and these are OKI, EM-333 and 0430AT. Ive hunted round on the web and found nothing.
The wires seem to be 3 grey and 1 blue.http://www.mycncuk.com/attachment.php?attachmentid=14856&stc=1http://www.mycncuk.com/attachment.php?attachmentid=14857&stc=1
Advice anyone ? Bin ?
Thanks
Pete
Ive had this 4 wire motor lying around for a couple of years, and it bugged me back then. Ive just started to look at dabbling with CNC, this time with the arduino and its bugging me again.
Has anyone come accross these? I suspect its out of an old printer. The only markings are on the bottom of the case and these are OKI, EM-333 and 0430AT. Ive hunted round on the web and found nothing.
The wires seem to be 3 grey and 1 blue.http://www.mycncuk.com/attachment.php?attachmentid=14856&stc=1http://www.mycncuk.com/attachment.php?attachmentid=14857&stc=1
Advice anyone ? Bin ?
Thanks
Pete