View Full Version : WANTED: 20mm rail
johnsattuk
03-11-2015, 03:33 PM
Looking for 20mm rail 2 off 800mm long with 4 carriages,
Looking for sr15mm rail 2 off 800mm long
Looking for 20mm rail 2 off 1000mm long with 4 carriages, or 2 off 25mm THK HR rails 1000mm long
might swap for two 25mm THK rails 792mm long with 4 HSR25CR carriages.
WHY
Jonathan
03-11-2015, 06:45 PM
I have some Hiwin HGH15 rails - if I recall correctly I have four 760mm long rails and two longer rails (1100-1200mm I think, will have to check), plus at least 10 bearings to go with them. All new, genuine Hiwin bought a few years ago before they started turning up everywhere.
Is that one THK rail you have available to swap, or two? If it's two then I may be interested for my X3 mill conversion.
johnsattuk
03-11-2015, 08:41 PM
Two rails
Also have two THK ball screws, nuts have 6 tracks 28 OD with 30 dia thread on one end, complete with INA thrust bearings.
They are 5/8" dia x 0.2" pitch very close to 1605 would give ~400mm travel
Powered by vBulletin® Version 4.2.5 Copyright © 2025 vBulletin Solutions Inc. All rights reserved.