hoezap
13-02-2016, 05:14 PM
Hello
Thank you for entering in my post
I would like to know which would the most profitable way to cut a 7.5 slot +-0.1 x 35mm deep opened from both sides, on aluminium 6082 T6.
I was watching and reading about Trochoidal milling, but I have never used this method before
https://www.secotools.com/en-GB/Global/Services--Support/Tool-Selection-Support/Trochoidal-Milling/
With this method you can use all the cutting edge with a small radial cutting depth
I could use 6mm slot-mill with 3 or 2 flutes with length 6 times Diameter, the maximum spindle speed on the machine is 10.000rev/min
What sort of parameters should I set for this cut?
The surface finish tolerance is 1.6
Spindle speed: 3000 rpm
Feed: 500mm/min
Circular interpolation dimeter 7.3mm
Would you put a finish cut?
May you please suggest the best cutter for this operation and best parameters?
Any suggestion will be very appreciative
Thankyou in advance for your help
Thank you for entering in my post
I would like to know which would the most profitable way to cut a 7.5 slot +-0.1 x 35mm deep opened from both sides, on aluminium 6082 T6.
I was watching and reading about Trochoidal milling, but I have never used this method before
https://www.secotools.com/en-GB/Global/Services--Support/Tool-Selection-Support/Trochoidal-Milling/
With this method you can use all the cutting edge with a small radial cutting depth
I could use 6mm slot-mill with 3 or 2 flutes with length 6 times Diameter, the maximum spindle speed on the machine is 10.000rev/min
What sort of parameters should I set for this cut?
The surface finish tolerance is 1.6
Spindle speed: 3000 rpm
Feed: 500mm/min
Circular interpolation dimeter 7.3mm
Would you put a finish cut?
May you please suggest the best cutter for this operation and best parameters?
Any suggestion will be very appreciative
Thankyou in advance for your help