View Full Version : Edge Probe + tool length probe on same input
Noplace
18-06-2016, 10:44 AM
Hi all, a simple problem to solve i reckon for u guys, got myself a cheap tool length probe and a decent digitizing / edge probe , both use the same input but one is normally open and other is normally closed, what can I do to allow usage of both without changing active high/low everytime i want to switch?
Sent from my HTC One_M8 using Tapatalk
komatias
18-06-2016, 11:12 AM
Hi all, a simple problem to solve i reckon for u guys, got myself a cheap tool length probe and a decent digitizing / edge probe , both use the same input but one is normally open and other is normally closed, what can I do to allow usage of both without changing active high/low everytime i want to switch?
Sent from my HTC One_M8 using Tapatalk
Look up inverting logic circuits :D
Powered by vBulletin® Version 4.2.5 Copyright © 2025 vBulletin Solutions Inc. All rights reserved.