Programming the 18F452

The following instructions refer to MPLab v6.4. If you're not using this please use the following as a guide along with the instructions for your particular software.



Download the latest version of the firmware RotaryVxxx.hex (xxx is the version number).

Run MPLab. In the 'Configure' menu choose the 'Select Device' option, change the device to 18F452.

In the 'File' menu select the 'Import' option and load the .hex file you downloaded above.

Select and enable your programmer in the 'Programmer' menu and then erase and program the device.

All done.




