Kearney and Trecker tool chain logic working in EMC2. Mechanically barcoded tools

Kearney and Trecker tool chain logic working in EMC2. Mechanically barcoded tools (1 min 30 sec)

Just got the ladder logic working for the tool chain. The tool reader reads the barcodes on each tool as it goes by. when the tool matches the tool asked for by EMC2 - the tool chain slows down - counts 2 more pockets and then stops and clamps. Went very well - emc2 is great software - flexible :)

(I's not mine! - Tom)

1. This media has no comments...