- Tab Content
- routercnc's Activity
- About Me
- Friends
- Video Library
-
Older Activity
-
18 Hours Agoroutercnc replied to a thread Setting up VFD to run without a controller in router table. in Spindles & Drive MotorsI couldn't open the link above. A while ago I made a video on wiring up a similar VFD, skip to ~36:00 minutes:...5 replies | 378 view(s)
-
1 Week Agoroutercnc replied to a thread BUILD LOG: Feedback on Improving Precision in XYZ Gantry Dispensing Machine in DIY Router Build LogsOK so it is a sort of pick and place machine with no real loads at the end effector (dispenser end)? And the positioning errors there when you just...2 replies | 947 view(s)
-
1 Week AgoI'm working on the electrical control side now and the original plan was to go for another AXBB-e since it has not missed a beat since I installed...12 replies | 17631 view(s)
-
1 Week AgoNext . . .12 replies | 17631 view(s)
About routercnc
Basic Information
- Age
- 52
About routercnc
- City:
- West Midlands
- Country:
- United Kingdom
- Interests:
- Engineering, model building
- Occupation:
- Engineer
Signature
Statistics
Total Posts
- Total Posts
- 1,730
- Posts Per Day
- 0.33
- Last Post
- Setting up VFD to run without a controller in router table. 18 Hours Ago
Total Thanks
- Total Thanks
- 75
General Information
- Last Activity
- 18 Hours Ago
- Join Date
- 25-05-2010
BSMCEO4U board is not recognized...