- Tab Content
- SteveNotlob's Activity
- About Me
- Tab Content
-
Older Activity
-
5 Days AgoSteveNotlob replied to a thread NEW MEMBER: New Member, a little experience with 'toy CNC' but got a bigger baby now :-) !! in New Member Introductionsm_c; Drives using 24v for motors and 5v for opto-couplers6 replies | 3128 view(s) -
5 Days AgoSteveNotlob replied to a thread NEW MEMBER: New Member, a little experience with 'toy CNC' but got a bigger baby now :-) !! in New Member IntroductionsHello again m_c; All motors and drives now tested and working OK. I'm hoping not to spend much as it is for hobby use and I couldn't justify...6 replies | 3128 view(s) -
5 Days AgoSteveNotlob replied to a thread Rusty Lead Screw - Best method to clean in Lead Screws, Nuts & SupportsHello NikosR. I have already put photos of my machine on the 'Introduction / Welcome sub-forum a week or so ago. I'm attaching some photos of the...6 replies | 2299 view(s) -
6 Days AgoSteveNotlob replied to a thread Rusty Lead Screw - Best method to clean in Lead Screws, Nuts & SupportsQuick update - I purchased a few brass wheels for the cordless drill today and so far, it seems to be going well on the cleanup. Going back to my...6 replies | 2299 view(s) -
1 Week AgoSteveNotlob replied to a thread Rusty Lead Screw - Best method to clean in Lead Screws, Nuts & SupportsThanks for the replies chaps. The rust is not too bad at one end but is quite bad at the other. I think the unit was a bit tilted in storage and...6 replies | 2299 view(s) -
1 Week AgoSteveNotlob started a thread Rusty Lead Screw - Best method to clean in Lead Screws, Nuts & SupportsHello all. I have recently purchased a machine and all seems OK so far (mechanically, not tested electrics yet) apart from the x-axis lead screw...6 replies | 2299 view(s) -
1 Week AgoSteveNotlob replied to a thread NEW MEMBER: New Member, a little experience with 'toy CNC' but got a bigger baby now :-) !! in New Member IntroductionsHello m_c, Thanks for the input. The machine owes me £200 already (£159 to buy it and around £40 in fuel to collect it) so I am thinking of taking...6 replies | 3128 view(s) -
1 Week AgoSteveNotlob started a thread NEW MEMBER: New Member, a little experience with 'toy CNC' but got a bigger baby now :-) !! in New Member IntroductionsHi all. I played around with a small, hobby CNC some years ago (home built by previous owner with 2020 profiles but he couldn't get electrics /...6 replies | 3128 view(s)
About SteveNotlob
Basic Information
About SteveNotlob
- City:
- Bolton
- Country:
- United Kingdom
Statistics
Total Posts
- Total Posts
- 8
- Posts Per Day
- 0.42
- Last Post
- New Member, a little experience with 'toy CNC' but got a bigger baby now :-) !! 5 Days Ago
Total Thanks
- Total Thanks
- 0
General Information
- Last Activity
- 19 Hours Ago
- Join Date
- 27-03-2026



Three axis CNC router