- Tab Content
- Clive S's Activity
- About Me
- Friends
- Video Library
-
Older Activity
-
4 Hours AgoLee Roberts replied to a thread Setting up VFD to run without a controller in router table. in Spindles & Drive Motorspdf attached from the link you couldn't use @routercnc...5 replies | 347 view(s)
-
2 Weeks AgoSome pictures would help. Also have you set the steps per the same for each motor. Have you wired the enable to the drives as a lot of drives work...1 replies | 1015 view(s)
Statistics
Total Posts
- Total Posts
- 3,341
- Posts Per Day
- 0.75
- Last Post
- Stepper motor problems. 2 Weeks Ago
Total Thanks
- Total Thanks
- 81
General Information
- Last Activity
- 1 Hour Ago
- Join Date
- 17-10-2012
Setting up VFD to run without a...