Up for sale is a good condition Denford StarMill ATC.
I've listed it on eBay for £1,500, but would take a £1,400 sale here as no fees to pays :)
https://www.ebay.co.uk/itm/112273431115
1988 vintage.
ATC has 3 positions.
Comes with three tools. (I think they're BT35)
Each function works from the control panel (spindle, drawbar, X/Y/Z axis etc.) but I never got around to using it with the crappy DOS software over a serial link.
My original aim was to convert to Mach3, but other projects got in the way and I never got around to it (I use my Triac most of the time anyway).
Comes with a full set of drawings / diagrams.
The table has a bit of light surface rust, but should come of with a bit of wire wool.
It does need an air pressure / regulator fitting.
If I can find a spare, I'll include it. Otherwise you'll need to fit one.
Collection from Nottingham strongly preferred.
Will just about fit in a big boot, although a small van would be easier!
Although I can pallet it up and ship it at cost (around £100) however I accept no responsibility for any damage if it's shipped.
I can supply a small trolley / table to sit it on if that's wanted? If not it'll skip the table.
I will not ship the table; that is collection only.
Any questions... let me know!
