Printable View
Hi there. I am new to the CNC world. I hope to love working with the new desktop CNC I recently bought. But am have some problems.
I was trying to change the speed settings on VFD and mistakenly cleaned all the settings back to their default.
The machine is an itech k6090t CNC with a delta sm300 VFD. It runs a 2.2kw water-cooled spindle, the controller is rich auto A11E
If anyone has the setting that would be a great help.
Thanks
ben
Isnt there a manual for the VFD somewhere? Where in Oxfordshire?
HI chaz, yes there is a manual oniline. i am near banbury.
So is that you dont know what the settings should be to allow the machine to run again?
Yes, that is right. The machine was working. I was looking for the right setting to put back into the VFD. I did find some, which are below. But the controller does not seem to turn the spindle on. I am NOT sure if these are the right settings for it. That is why I was hoping someone would have them. The manual is a bit confusing to me as I am new to the CNC and VFD world.
00.21=1
01.00=400
01.01=400
02.16=2
02.17=34
03.11=101.0
05.01=8.00
05.02=2.20
05.04=2
05.03=23999
06.06=4
06.08=5.0
07.01=40
07.02=2.0
07.03=2.0
07.04=5.00
The attachments dont work but Ive found a manual.
00-23, is that set to 0?
If you bridge the terminal for 'run', does it start?
Are you giving it a speed reference and if so, how?
00-30, should be set to 2 and then PR3-00 should be set to 1 (default).
Why is 3-11 101 and not 100%?
5.03 should be 24000 most likely.
Might be worth me giving you a call to help. PM Me a number that I can Whatsapp you on, as you can then show me what you see etc.
Hi Ben welcome to the community and good luck with your adventure!Quote:
Originally Posted by artisan