Denford Orac - Centroid / ATC (Options Available)

I bought this lovely little Denford Orac a few months ago and have installed Centroid Acorn and an ATC. This is teh version with the pneumatic chuck. I'm not using the machine, I have large lathes available to me, so am letting it go. The lathe is also sitting on a table with wheels which will be included.

I am willing to sell the machine in a few configurations.

1. With or without the Centroid setup, this includes the Centroid Hardware, PC, Keyboard and relevant Lathe Software Licenses (tied to the board). If you would prefer to save some cash, I'd be happy to remove the Centroid system and show you the wiring to convert to another control system.

2. With or without the ATC. The ATC is working however needs to be adjusted in terms of placement / tool height, so will need some fettling. I'm happy to remove the ATC and put the original Multifix compound slide back on, this comes with 3 AA tool holders.

For the machine with everything, I'm willing to sell for £1,800. Removing the Centroid setup, reduces the cost by £700. Removing the ATC, reduces it by £300, therefore happy to sell with the minimum bits at £800 (including the Multifix Tooling which is high end Swiss toolholding.

Here's a vid showing the traditional 'pawn' being turned - https://www.youtube.com/watch?v=tvbYHh2ZZ1k
Any questions, please give me a shout.

Collection Preferred but happy to offer a drop off if not too far from us (near Witney, Oxfordshire)

Attachment 32614Attachment 32615Attachment 32616