Printable View
I bought a Seig CQ6230B/910 lathe & a couple of years ago it went 'POP' & let all the smoke out. Since then it's just been sat there laughing at me.
I've wired it up with a temp power supply but it only works if I manually operate one of the contactors.
On the basis that me & elecktrickery don't get on very well at all, is there anyone in the Nott's/Derbys area who would care to have a poke & prod on my behalf?
Hi Chas
Do you have any wiring diagrams for your lathe?
Where in Notts are you?
Andy
Yes, got the Chinglish manual but sadly no scanner.Quote:
Originally Posted by audioandy
I'm near Ripley, 10mins from Jnc 26/27.
I need to source a new power supply that will fit in the cabinet & possibly a replacement contactor. I don't know where to even start looking for the correct ones?
I'm at Junc 28 so not far away, don't mind nipping over and having a look sometime.
PM me your phone number I will give you a ring to arrange a time.
Andy
Much obliged & PM sent.
Errmmm, that's not your photo as an avatar is it ?
No don't be daft it my identical brother!Quote:
Originally Posted by Chas