Printable View
Hi All,
Just an intro and saying Hi.
Just purchased an Emach (*Please* say I've not cocked up!) EM900 to produce MDF shapes letters and similar.
Hoping anyone can help out if I need some hand-holding sometime through the forums.
Thanks in advance guys n gals
Get some pictures up of it ,or a link to the exact machine ,I cant find any info on them other than a few pissed off customers in the blog below
http://trickydoubt.blogspot.co.uk/?view=classic.
maybe if it came at a good price its not all bad and could be improved on.
another emach thread
http://www.mycncuk.com/threads/5827-...th-new-machine
I'm sure that if the machine has any problems they can be sorted out here.
Thanks Eddycurrent... I have seen some comments and this is quite worrying. The machine apparently works and has been used, but to what degree of accuracy I am unsure.
Its an Em 900 machine built 2006, so perhaps before the rot set in.
Pics as I have them, I'm hoping it's ready to go, and if needs "Alterations" I can get them done. I'm old school C & G ONC engineer (Machinist style) and can wield a spanner, hammer, gas axe with the best of 'em :-)
Will post in correct forum a few pics
Welcome and I hope you have success with your new machine.
Steve