Put the rails on the aluminium extrusions and run the caliper.
Attachment 23742
Attachment 23743
Printable View
Put the rails on the aluminium extrusions and run the caliper.
Attachment 23742
Attachment 23743
I'm going to glue 2 T nuts together so they can't twist in the slot for my clamps to make it easier to release, move and retighten.
Is that M6 thread with a 10mm slot?
Smart stuff ;)Quote:
Originally Posted by Desertboy
Or you can just buy the longer ones?
They cant be "dropped down" but thats true if you glue two aswell
Skickat från min SM-G955F via Tapatalk
Thanks Robert.Quote:
Originally Posted by Nr1madman
Yes it is frustrating but the sooner you calm, improvise and adapt you can solve the problem, it took me one whole day!
Those are M6 with 8mm slot, they was suppose to be 19.5mm but actually they are 19.28mm.Quote:
Originally Posted by Desertboy
Why didn't you write that yesterday???:joyous:Quote:
Originally Posted by Desertboy
If you have a router table make them yourself that's my plan if I ever need to mount hiwin's again with extrusion.
But if you need more I can get them from KJN and post them to you for cost I'm 3 miles (4km) away from them and need to go for more T nuts this week for my clamps so it;s no hassle.
They're £4 for 10 I needed 100 for my hiwin's so I bitterly know this lol.
Attachment 23744
Took this in their entrance, this would cost stupid money lol. Extrusion is not cheap.
Quote:
Originally Posted by Desertboy
Thanks mate,that is very kind of you, I appreciate it.
For now I am good but I will keep in mind your offer, thanks again!!!
Where can I find HDT5 pulleys with 10mm bore, any suggestion?
http://www.beltingonline.com - Very good to deal with.Quote:
Originally Posted by Nickhofen