Yes aspire, Jazz did it.
Not curved, hmm.. could use CNCtoolkit to wrap it round a profile. Finally an excuse to make the 5-axis spindle mount!
Printable View
Ta, got it.
Also found the DXF for it.
Translated onto brass at 120mm round 20 degree V carve it says 2 hours 57 cutting
90 degree cutter is 1 hour 43
Probably got it twice.
I think 20 degree will cut a bit too deep? I doubt the time estimates will be anywhere near unless your machine acceleration is exceptionally high. Still it'll be interesting to find out.
Any chance of a copy of the code as well?:encouragement:
Thanks.
If I remember right thats roughly about what it took me when I did it.?? But it's been that long since I did it I can't remember.
Like Jon says 20 deg will cut deep but I'm sure you will have sussed that and limited it's depth.? I've seen a nice one done with aspire that cuts the bottoms of deep area's flat and rest Vcarved.
Thanks JAZZ. pm sent.
Ian
Got it thanks!
What size/type cutters did you use for it?
Ian