Re: Closing the loop with Linuxcnc, adding encoders to Mesa FPGA?
Or you could go down this route https://forum.linuxcnc.org/9-install...start=0#164287
.
There are now quite a few iso's floating around with Linux mint that some members have made with 2.8 and 2.9 that work straight out of the box
Re: Closing the loop with Linuxcnc, adding encoders to Mesa FPGA?
Quote:
Originally Posted by
Clive S
2.8 has dual homing right? And I think a config for the Mesa card.
Re: Closing the loop with Linuxcnc, adding encoders to Mesa FPGA?
Quote:
Originally Posted by
Desertboy
2.8 has dual homing right? And I think a config for the Mesa card.
Yes 2.8 and 2.9 has it. It is a bit different than 2.7 But that now is a dead duck
